VAG 2.0 TFSI EA113 Balance Shaft Delete Kit with Tensioner and Seals

Balance Shaft Delete Kit for VAG EA113 Petrol TFSI Engines

The OE sprocket driving the balance shaft on the EA113 engines is commonly known for failing. High mileage and revving the engine hard are two factors that mainly cause this failure. The balance shaft rotates at twice the engine rev speed, so as you can imagine, when revving the engine over 6/7000 revs, it's going to be under a lot of strain.

When the OE sprocket fails, it is highly likely to cause damage to the chain, which drives the oil pump. If this happens, it can casue a lot of damage to other parts of the vehicles engine, so this preventative measure is highly recommended!

Better throttle response

Preventing the risk of engine failure

There are two ways to perform the balance shaft delete on these engines.

You can either leave the original chain in place, making the process much easier and requires less parts but upon stripping down to perform the delete, it may become apparant that the chain also requires replacement.

If this is the case, we offer the Full Kit with Replacement Chain, this includes a Chain, Oil Pump Sprocket Bolt & Crank Seal. It is recommended that this kit is used, however, when the chain needs replacing the Cambelt & Water Pump also need removing, so it is recommeneded that these are changed at the same time. Links to these parts can be found below in this listing.

This Kit Consists of:

1x Balance Shaft Delete Sprocket
1x Pick Up Pipe Seal
1x Oil Pump Chain Tensioner
1x Tube of Silicone Sealing Paste
1x Crankshaft Seal (FULL KIT ONLY)
1x Timing Chain (FULL KIT ONLY)
1x Oil Pump Sprocket Bolt (FULL KIT ONLY)

We strongly recommend that the Pickup Pipe is replaced when performing this balance shaft delete. We have replacements listed here:

https://www.darksidedevelopments.co.uk/products/engine-sump-pickup-pipe-suction-line-for-ea113-tfsi-petrol-engines.html

Replacement Cambelt Kit:

https://www.darksidedevelopments.co.uk/products/cambelt-kit-for-vag-ea113-2-0-tfsi-petrol-engines-06f198119a.html

Replacement Water Pump:

https://www.darksidedevelopments.co.uk/products/water-pump-for-vag-ea113-2-0-tfsi-petrol-engines-06f-121-011-x-r-b.html

This Kit will fit the following Vehicles:

Audi A3 / S3 - AXX (200) BPY (200) BWA (200) BZC (256) CDLC (256) BHZ (265) CDLA (265)

Audi TT / TTS Coupe / Roadster - BWA (200) BPY (200) CDMA (265) CDLA (265) CDLB (272)

Seat Altea - BWA (200)

Seat Leon - BWA (200) BWJ (241) CDLD (241) CDLA (265)

Seat Toledo - BWA (200)

Skoda Octavia - BWA (200)

VW Bora - BWA (200) BPY (200)

VW Eos - BPY (200) BWA (200)

VW Golf - AXX (200) BPY (200) BWA (200) BYD (230) CDLG (235) CRZA (256) CDLC (256) CDLF (271)

VW Golf Cabriolet - CDLG (235) CRZA (256) CDLC (256) CDLA (265)

VW Jetta - AXX (200) BPY (200) BWA (200)

VW Passat / Variant - AXX (200) BPY (200) BWA (200)

VW Scirocco - CDLC (256) CDLA (265) CDLK (280)

VW Vento - BWA (200) BPY (200)

Replaces Genuine VW Sprocket Part Numbers:

06F105243C - 06F105243 C - 06F 105 243 C