Darkside Caddy Mk3 / Mk4 Lowering Kit with H&R Front Springs

Darkside Caddy 2K Mk3 / Mk4 Rear Lowering Kit with H&R Front Lowering Springs

Fits Caddy Mk3 / Mk4 2K Van Rear Axle (FWD & 4Motion)

H&R Front Springs for the VW Caddy Mk3 / Mk4 which will give between a 40 - 60mm drop when settled

The H&R Sport Springs lower the vehicle center of gravity and reduce body roll for better handling as well as reducing the large arch gap that comes on the van from the factory

Our lastest design of rear lowering kit combines both our previous low and super low kits

REAR Shackles:

Hidden shackles and more ground clearance
CNC Laser Cut and Zinc Electroplated to prevent corrosion
Shackle Support Blocks to reduce side to side axle movement
The Lowering Kit allows you to flip the rear axle on your Caddy 2K Van and then adjust the ride height to suit
This kit will also fit Maxi and 4Motion models

WE ALSO OFFER THIS KIT FOR VEHICLES WITH TWIN REAR LEAF SPRINGS. THIS KIT IS SUPPLIED WITH LONGER BOLTS FOR THE SANDWICH PLATES

PLEASE SELECT FROM THE ABOVE OPTIONS IF YOU REQUIRE THIS.

This Kit Consists of:

H&R Front Lowering Springs
4 x Adjustable Shackle Plates (2 per side)
6 x Axle Sandwich Plates (3 Per Side)
8 x Hi-Tensile Bolts
8 x Nyloc Nuts
16 x Washers
2 x Shackle Support Blocks

PLEASE NOTE - THIS KIT IS FOR 'OFF ROAD USE' ONLY

ONCE FITTED YOU MAY NOTICE SIDE TO SIDE MOVEMENT IN THE REAR AXLE, THIS MOVEMENT IS NORMAL AND PRESENT FROM FACTORY BUT NOT USUALLY NOTICEABLE WITH THE STOCK WHEELS AND RIDE HEIGHT. WITH THE VAN LOWERED THE WHEEL BECOMES CLOSER TO THE BODY TO THIS MOVEMENT IS HIGHLIGHTED AND EASIER TO NOTICE, MORE SO WITH AFTERMARKET WHEELS THAT PROTUDE FURTHER FROM THE ARCH

THE PARTS ARE CNC LASER CUT AND THEN ZINC ELECTROPLATED TO PREVENT CORROSION

We also have a full fitting guide, please see our Website

AXLE WEIGHTS

To work out your vehicles axles weights you will first need to locate the VIN / Chassis sticker on your model. This location varies between models but can often be found within the engine bay or door shuts.

Once you have located the sticker on your model you can now work out the load ratings from the information given: